A DIY Microhydro Plant

I don’t know yet how to make the distribution box that has to connect to 250mm PVC pipe on one side, and to four 4″ brass valves on the other side, with a pressure gauge on top. Gabriel acting as center point, his son as end load, and I as the controlling factor on the front of the pipe section.This piece of pipe had to be bent in three places, to give enough curving without too much weakening. The water flowed nicely along the channel, but it was clear that the slope was not constant, so I asked Gabriel to deepen both the second half of the channel, and the trench for the first two sections of tube.

Source: ludens.cl